Well designed with 3D-work by Seamax Marine, this Deluxe Boat Launching Wheels system is made by the hardest marine grade T6 aluminum alloy with CNC processing and shiny looking anodized coating on all aluminum parts. Thus the product is good for saltwater use. Small parts are all made by solid stainless steel. The air filled tire is lab-tested (1000 LBS), and is great to support a MAX loading of 600 LBS in all condition. A great add-on for inflatable, aluminum and fiberglass boats.
BENEFIT of its new design - With the 4 stages of length and 4 wheel arm position, the dolly can be adjusted while afloat in the boat, leaving or coming into the dock. The dolly system can also bring different performance position for boat launching. The wheel arm length increment is 2.5” per stage. Plus the wheel’s diameter, the range of length is 23 - 30 inches.
The wheel arm has 60 or 90 degree locking position to move up and down. It frees up more space on the top and side of the transom. The lower 60 degree position lets the wheels run at the same level as the prop; and thus turns the dolly as a prop guard at rocky beaches.
The transom bracket installation area is about 8 x 3 inches. Shorter transom bracket design brings more possible installation for all type of boats with different transom. The brackets ca be installed at the water line top position, so to avoid the water comes into the screw holes. Two bottom collinear bolts give the bracket extra strength to stabilize.
TRIPLE heavy duty, TRIPLE quality! Product is made by Seamax Canada with 2 years limited warranty and 100% Customer Satisfaction guaranteed! The Quick Operation Features of the Deluxe Boat Dolly include: spring load locking pin for wheel arm position adjustment; solid spring load buttons for wheel arm length adjustment; and quick released lock pin for wheel arm and wheel bearing.
ADJUSTABLE DESIGN: These wheels have 4 adjustment positions for length and angle to adjust the leg length, push in the spring loaded buttons on each side of the leg and either pull or push to lengthen or shorten. To adjust the leg angle, push down on the spring loaded bar near the top of the leg assembly and move the leg assembly to the desired location. To remove the leg assembly from the bracket, pull out the quick release pin located at the top of the leg assembly.
MAX LOAD: This dolly set is designed for boats with solid outboard transom, the length of the boat should be less than 16 FT for easier moving. Total weight should not exceed 600 Lbs including boat, outboard and all accessories.
INSTALLATION: This dolly set should only be installed by an adult with some experience in working with tools. To install the wheel set properly, you will need to drill 6 holes (5/16”) in the plywood transom for the mounting brackets (3 holes per bracket). It is very important to locate the position of the holes correctly (2 holes at lower position, 1 hole at upper position). Please check carefully including checking the wheel arm position before starting to drill any holes.
MAINTENANCE: Wash it after using from salt water or sandy beach. Check tire pressure before every using. Don’t store the wheels under the sun or beside the heat to maximize its life time. Take the wheel arm off from the transom bracket when store your boat. Lube the spring load dolly system is necessary. Keep the lock pin on the dolly bracket.
TIRE INFLATION: Dolly tires may not be fully inflated when shipping; please only give 15-20 PSI pressure at room temperature before using. Best to use portable type digital air pump in case tire over inflated. Tire over inflated will cause damage and the warranty is not covered. Dual wheel kit is available for this dolly for heavy loading application.
WARRANTY: Manufacturer 2 years Parts Limited Warranty within USA & Canada. 30 days free replacement on any defective ransom wheel sets. Please return the product or parts to the retailer you purchased them from if there is a warranty issue. You may contact the retailer for technical